Effect of wax composition on the injection molding of carbonyliron powder with LDPE

K. C. Hsu, C. C. Lin, G. M. Lo

Research output: Contribution to journalArticlepeer-review

9 Citations (Scopus)

Abstract

The effect of waxes on the injection molding of carbonyl iron powder with low-density polyethylene (LDPE) have been examined. Four waxes, paraffin wax (PW), polyethylene wax (PEW), carnauba wax (CW) and acrawax (AW) were selected and compared. Experimental results indicated that the LDPE-rich phase was found to be separated from the wax-rich phase in the binder mixture containing AW, CW of PW, Polar AW or CW showed stronger interactions or adsorptions with iron powder than other nonpolar waxes. AW/LDPE and CW/LDPE mixtures appeared to exhibit higher viscosity, greater pseudoplasticity and lower flow activation energy than PW/LDPE and PEW/LDPE mixtures. Tensile bar specimens of all binder mixtures could be injection molded at an injection temperature of around 170-190°C, and a pressure of around 5-6 MPa. Except for the PEW/LDPE mixture the parts derived from the other three binder mixtures showed good surface appearance following debinding and sintering. Specimens based on the PW/LDPE mixture exhibited the highest tensile strength in the resulting sintered parts, followed those based on CW/LDPE, AW/LDPE, and PEW/LDPE mixtures. The difference in tensile strength of each part results from different flow properties of each wax/LDPE mixture.

Original languageEnglish
Pages (from-to)181-187
Number of pages7
JournalCanadian Metallurgical Quarterly
Volume35
Issue number2
DOIs
Publication statusPublished - 1996 Apr

ASJC Scopus subject areas

  • Metals and Alloys
  • Industrial and Manufacturing Engineering

Fingerprint Dive into the research topics of 'Effect of wax composition on the injection molding of carbonyliron powder with LDPE'. Together they form a unique fingerprint.

Cite this